by PICEM75 Ice Maker & Dispenser Countertop Ice Cube Making Machine
DESCRIPTION 1 1 - Viewing Window 3 2 2 - Front Cover 12 3 - LCD Display 4 - Control Panel 5 - Ice Cube Dispenser Shoot 11 4 6 - Ice Cube Dispenser Puncher 10 7 - Water Drip Tray 5 8 - Water Outlet 6 9 9 - Fan Cover 10 - Water Reservoir Access Door 11 - Side Shell 8 7 12 - Top Cover 13 - Back Cover 14 - Water Inlet Hole 13 15 - Power Cord 16 - Drain Pipe 14 16 15 Before/First Use of Your Ice Maker 1. During transportation, the incline angle of the cabinet should not be over 45°.
CONTROL PANEL OPERATION PICEM75 SMALL LARGE WATER ON/OFF Display Explanation There is not enough water in the water reservoir, add more water. Ice making is in progress. If there is an “S” at the top right side of the symbol, the machine is making small ice. If there is an “L” at the bottom right side of the symbol, the machine is making large ice. The unit is dispensing ice.
OPERATING IN STRUCTIONS Step 1: Plug the machine into an outlet. Step 2: Open the water reservoir access door and add water as shown in sketch A. You can also add water automatically by connecting the unit to a water source as shown in sketch B. Sketch A Add Water Manually Sketch B Connect the Unit to a Water Faucet A. to water pipe B. to water faucet OPEN C. to Unit Add water manually If the unit is on, and you see the indicator, then you need to add water to the water reservoir.
Step 7: Once the ice making cycle is finished, the water tray will tilt forward and the remaining water will flow back into the water reservoir, and then the ice cubes will drop from the fingers. Step 8 In about 15-35 seconds, the water tray will tilt backward and the ice produced in the previous cycle will be pushed to the ice reservoir directly. Then the unit will repeat steps 4 to 6 again until the ice tray is full or there is no water remaining in the water reservoir.
SAFETY NOTICE In order to avoid any accidents, please refer to the following: 1. Disconnect power before servicing. 2. Do not pull directly on the wire when plugging or unplugging the unit. 3. If ice is abnormal, please call the seller. 4. It is normal for the compressor and condenser surface to reach temperatures between 158°F and 194°F during operation and surrounding areas may be hot. Please don't touch it. 5. Due to fast freezing, ice cubes may appear “Cloudy”.
TROUBLESHOOTING 1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button has been pushed off during an ice making cycle, then small ice chips may form and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet to remove the ice chips, then restarting. 2. Please restart the ice maker by pressing Stop and then Start.
www.PyleUSA.
PICEM75 Ice Maker & Dispenser, Countertop Ice Cube Making Machine (2 Sizes of Ice Cubes) Features: • Simple & Hassle-Free Ice Making • Just Add Water & Press the Button • Convenient Tabletop Ice Dispenser Design • Quick Ice Making: Ready to Serve in 9 Minutes • Ability to Connect Water Supply Pipe Line for Direct Water Tapping • Choose (2) Different Sized Ice Cubes • Creates Small or Large Ice Cubes • Makes up to 33 lbs.
by