User Manual

www.NutriChefKitchen.com
9
www.NutriChefKitchen.com
8
1. Real Time Setting: Press the SET button one time, hour blinking,
press the button to set hour, press the SET button one time,
minutes ash, press the button to set minutes.
2. The timing for the machine start on time setting: Press the SET button
3 times, hour blinking, press the button to set hour, press the SET
button one time, minutes ash, press the button to set minutes
3. Set the machine power o time: Press the SET button 5 times, hour
blinking, press the button to set hour, press the SET button one time,
minutes ash, press the button to set minutes
4. The timer functions take on use: Press to set timer, set the cycle
timer function mode: time power on time power o time o
power on and o, power on default time is 8:00, power o default time
is 12:00.
VIII. FAULTS AND TREATMENTS
Problem SolutionPossible Causes
POWER indicator
light is not
turning on
Power Source is
not switched ON
1. Ensure that the source voltage
matches the rated supply voltage
2. Check the power cord if correctly
connected
3. Internal components are damaged.
Refer all servicing to qualied
service personnel.
ICE FULL
indicator is lit
1. Ice Storage
Basket is full.
2. Low-
temperature
protection
(temperature is
lower than 41°F)
1. Remove ice from Ice storage basket
2. Move the Ice maker to a warmer
place, where the ambient
temperature is higher than 41°F.
Malfunction
indicator
light ashes
Ice making box
reset in bad
condition
1. Check whether any foreign body
got stuck in the ice making box.
2. Internal components are damaged.
Refer all servicing to qualied
service personnel.
IX. PROPER CARE AND CLEANING
1. Make sure to unplug the appliance before cleaning and if it will not be
used for a long time.
2. Use a damp cloth to clean both the interior and exterior of the
appliance.
3. Water tank cleaning
• Unscrew the nut of water outlet, drain o the water.
• Pour clean water into the water tank, use a clean cloth to wipe water
tank around. Pour clean water again until the owing out water is clean,
and then drain o water and grip the nut.
• Do not use organic solvents, boiling water, cleaning agents, strong acids,
strong acid and Alkali etc substances for cleaning.
Problem SolutionPossible Causes
ADD WATER
Indicator Light
is on
1. Water reservoir
is empty.
2. Water supply
system is
damaged.
1. Add clean water.
2. Call Customer Service.
Ice making
performance
is poor
1. Air Inlet/Outlet
is blocked
2. Water tempe-
rature is too high
3. Ambient tem-
perature is too
high.
4. Refrigerant is
leaking and/or
refrigerating
system is
damaged.
1. Clean the Air Inlet/Outlet
2. Fill with room temperature water
3. Move the Portable Ice Maker to a
cooler place, where the ambient
temperature is lower than 95°F
or 35°C
4. Call Customer Service
Portable Ice
Maker is noisy
Fan or pump is
damaged
Call Customer Service