User Manual

www.NutriChefKitchen.com

64 Oz. Nitro Cold Brew Coffee Maker

NCNTROCB10

Stainless Steel Homebrew Coee Keg System Kit with

Pressure Relieving Valve & Stout Creamer Faucet

UNIT OPERATION INSTRUCTION

1. Stainless Steel Mini Keg 64oz

2. Stainless Steel Stout Faucet

3. Black Plastic Tap Handle

4. Stainless Steel Spear

with Pressure Relieving Valve 75PSI

5. Stainless Steel N2O or N2 Cartridge Holder

6. SS Wrench

7. Keg Cleaning Brush

8. Faucet Brush

9. Silicone Hose

PART ONE: SPEAR ASSEMBLY

1. Please clean mini keg, cap, spear body, faucet and

coee hose with warm water and mild soap before use.

2. Pour cold water/milk and cold brew coee base

(Catesse/Concentrate) into keg.

NOTE:

• Percentage of catesse and cold water depend on your

experience, maybe 20:1, 15:1 or others.

• Total liquid volume is 60%-75% of keg capacity.

Please keep in mind that you need to leave enough

space in the keg to inject the gas cartridge into.

3. Cut coee hose according to keg height and insert

into Spear, make Sure hose can touch bottom of keg

without overlong or overshort.

Remark: if hose is too short, coee would not be tapped

completely. But if hose is too long, it may crimp inside the

keg, also caused by incomplete tapping.

4. Install Faucet into Spear Body, make sure the

connection is proper and tight.

Remark: Improper combination would cause leakage of

coee liquid.

5. Place nonthread N2 or N2O cartridge into SS cartridge

holder, connect the whole part to the gas in connection

of Spear, hear ‘Whistle’ sound of nitrogen injection.

6. Shake cold brew coee and Nitrogen Gas to mix well,

then put it to refrigerator for 1 hours at least.

7. Take whole setup from fridge, place the glass to the

nozzle and then pull the handle to the front slowly,

enjoy your Nitro Coee.

PAGE 1
NCNTROCB10 64 Oz. Nitro Cold Brew Coffee Maker 2. Pour cold water/milk and cold brew coffee base (Cafitesse/Concentrate) into keg. Stainless Steel Homebrew Coffee Keg System Kit with Pressure Relieving Valve & Stout Creamer Faucet 5. Place nonthread N2 or N2O cartridge into SS cartridge holder, connect the whole part to the gas in connection of Spear, hear ‘Whistle’ sound of nitrogen injection.
PAGE 2
PART TWO: TROUBLESHOOTING GUIDE 1. Faucet Leakage Solution: There's a 4 hole nut on cross bar of spear, so you can use standard wrench to install faucet tightly. 5. Notice: When the last drop of cold brew coffee is finished, pull the faucet handle to completely remove the nitrogen gas before unscrewing the spear system. PART THREE: QUICK CLEANING GUIDE • Fill keg with hot water. – Repeat 3 times. • Rinse the hose with hot water.