Instructions / Assembly
www.NutrichefKitchen.com 5
BEFORE FIRST USE
1. Unpack the appliance, then check and make sure that all the accessories
including ice basket and ice scoop etc. are complete. Please contact with the
client service department if some accessories are missed.
2. Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
3. The incline angle of the ice maker cabinet should not exceed 45° during
transportation or use. Do not turn the ice maker upside down. Doing so could
cause the compressor or refrigerating system to operate incorrectly.
Please allow time for the uids in the compressor to settle after the ice maker
is moved or transported. Before using the ice maker for the rst time, please
wait for 2 hours after the unit has been leveled and positioned in the proper
place.
4. The appliance must be placed on a dry and level surface with sucient
ventilation, far from heat sources such as ovens, heaters and corrosive gases.
Leave a 15cm clearance on all sides of the ice maker for proper ventilation.
5. Do not ll the water reservoir with hot water. This may damage the ice maker.
It is best to ll the water reservoir with water of room temperature or lower.
6. Do not use the appliance at a very cold environment (lower than 5°C or 41°F).
7. Clean the appliance by following the operation of “CLEANING AND
MAINTENANCE” before operate.
USING YOUR ICE MAKER
1. Ensure that the drain plug at the back of ice maker is closed well.
2. Plug the ice maker into the wall outlet, the “ ” indicator ashes.
NOTE: Please make the ice maker rest for 30 minutes before using if it has
been moved.
3. Open the front lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: Do not ll above the MAX water level mark.
5. Replace the ice basket and close the front lid.
6. Press the “ON/OFF” key and the “ ” indicator lights solidly.
7. The ice-making cycle will last approximately 20-30 minutes, depending on the
ambient temperature and water temperature.