Use and Care Manual

6. During drying process, you can change or check the drying time.

Press the UPPER TEMP button rst, then press the + or - button. Press UPPER

TIME button, you can check the setting time.

Note: the operation of lower layer is same as the upper layer.

7. During drying process, press the UPPER POWER ON/OFF button, all functions

will be paused. Screen no display.

Note: the operation of lower layer is same as the upper layer.

8. In standby mode, you can press the UPPER POWER ON/OFF button directly to

get into default mode (TIME:10 hours TEMP: 71°C/160°F). You also can change

the drying time and temp if needed.

Note: the operation of lower layer is same as the upper layer.

9. When the set time counts down to 00:00, the heating element stops working

rst. The fan will continue running for 10 seconds and the buzzer rings 20 times

"beep" sound (1 time/second).

10. Unplug the unit from the power point.

NOTE:

· Set low temperature for thin/small pieces of food or for a small load of food.

Set high temperature for drying thick/big pieces of food and large loads.

The thermostat can also be used to decrease the temperature as the food is near

the end of its drying cycle making it easier to control the nal moisture level in

the food.

· Make sure that the fan base is always in place when operating the dryer. If you do

not have time to dry all the food in one day, you can dry them the next day.

In this case, you should store the food in a container/polyethylene bag and put it

in the freezer.

Hints

This dehydrator includes 20 trays and an overheat protection. The host contains

heating elements, motor, fan and thermostat.

· The air vents on the tray allow air to be circulated.

· Using a controlled heat temperature. Air from the back ow into each tray drying

moisture.