User Manual

Operating Instructions

Step 1

Plug in the machine into the socket.

Step 2

Open the water reservoir access door and add water as sketch A.

If your unit is ZB-10B or ZB-10C, you can add water with both sketch A and sketch B.

Sketch A

Add Water by Manual(All Three models)

Sketch B

Connect Unit to Water Faucet(ZB-10B & ZB-10C only)

If the unit is on ice making, indicator is on, but want to make more ice, then add water to the water

reservoir, but please take out the ice first, then add one full cup of water so as to avoid overflow of water

when the ice melt.

Step 3

Press ON/OFF button to start the machine.

Step 4

Water will be pumped into the water tray from the water reservoir automatically, this takes about 30

seconds

Note: If no water is pumped to the water tray over two cycles but the water in reservoir is enough, then

please open the drain cap, and let several drops water runs out. Then press ON/OFF button

again to restart the unit

Step 5

Select the button S/SMALL, M, L/LARGE to choose the ice size you may need

Note: when temperature lower than 15degrees, S/SMALL is recommended, when temperature over

30degrees, L/LARGE ice is recommended.

Step 6

Ice making cycle begins, ice will be frozen onto the evaporator fingers.

Note: the ice making time depends on the ambient temperature

Downloaded from www.Manualslib.com manuals search engine