Ice Maker User Manual PICEM75 Downloaded from www.Manualslib.com manuals search engine NutrichefKitchen.
Description 1 Viewing window 2 Front Cover 3 LCD Display 4 Control Panel 5 Ice cube dispenser shoot 6 Ice cube dispenser puncher 7 Water drip tray 8 Water Outlet 9 Fan Cover 10 Water reservoir access door 11 Side shell 12 Top cover 13 Back cover 14 Water inlet hole 15 Power cord 16 Drain pipe Before/First Use of Your Ice Maker 1.During transportation, the incline angle of the cabinet should not be over 45° .Do not turn the Ice maker upside down. As this may damage the compressor and sealed system. 2.
Control Panel Operation ZB-10A and ZB-10C Display ZB-10B Explanation Water is not enough in water reservoir, need to add water Ice on making, if S at right top hand of it, then means small size ice on making if M at right bottom hand, then means middle size ice on making if L at right bottom hand, then means large size ice on making Unit is on ice dropping process Ice is full Button SMALL or S M LARGE or L Operation Press it to select small size ice Press it to select middle size ice (for ZB-10A and Z
Operating Instructions Step 1 Plug in the machine into the socket. Step 2 Open the water reservoir access door and add water as sketch A. If your unit is ZB-10B or ZB-10C, you can add water with both sketch A and sketch B.
Step 7 Once ice making cycle is finished, the water tray will tilt forward; the remaining water flows back to the water reservoir and the ice cubes will drop from the fingers.
Safety Notice In order to avoid any accidents, please refer to following operation: 1. Disconnect power before servicing. 2. Do not pull directly on wire when plugging or unplugging the unit. 3. If ice is abnormal, please call the seller. 4. It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be hot. Please don't touch it. 5. Due to fast freezing, ice cubes may appear “Cloudy”.
Troubleshooting 1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button has been pushed off during an ice making cycle, small ice chips may formed and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting. 2. Please restart the ice maker by pressing Stop and then Start.
