Ice Maker User Manual PICEM35 NutrichefKitchen.
Description 1 Upper Cover 2 Front Cover 3 Control Panel 4 Ice Basket 5 Water Reservoir 6 Back Cover 7 Fan Cover 8 Fan 9 Socket 10 Plug 11 Drain pipe Before/First Use of Your Ice Maker 1.During transportation, the incline angle of the cabinet should not be over 45° .Do not turn the Ice maker upside down. As this may damage the compressor and sealed system. 2.
Control Panel Operation press this button to turn the machine on press this button to turn the machine off press this button to change which time need to be changed press this button to set the time ice full indicator, it turns on when the ice is full deficient indicator, it turns on if water in water reservoir is not enough Notice: please make sure the water is not over the max water level ice making indicator, it is running when the machine is on ice making turn on and turn off indicator, machine turn
Operating Instructions Step 1. Plug in the machine into the socket. Step 2. Add water to the water tank with cup included in the machine. Step 3. Press “ON” to start the machine. Step 4. Water is pumped into the water tray from the water reservoir. It takes about 30 seconds Note: If no water is pumped up to the water tray over two cycles but the water in water tank is enough, then please open the drain cap, and let several drops water runs out.Then press to restart the unit Step 5. Ice making cycle begins.
2.Turn On: press button “TIME” till the indicator ON beside the time area lights up, then press “TIME” and “SET” alternatively to change the time, after the time flash stops, press “SET” again till the indicator ON beside the time area is always lights up. 3.Turn off: button “TIME” till the indicator OFF beside the time area lights up, then press “TIME” and “SET” alternatively to change the time, after the time flash stops, press “SET” again till the indicator OFF beside the time area is always lights up.
Safety Notice In order to avoid any accidents, please refer to following operation: 1. Disconnect power before servicing. 2. Do not pull directly on wire when plugging or unplugging the unit. 3. If ice is abnormal, please call the seller. 4. It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be hot. Please don't touch it. 5. Due to fast freezing, ice cubes may appear “Cloudy”.
Problem Possible Cause Suggested Solutions The compressor works abnormally with a Buzzing noise The voltage is lower than recommended Stop the Ice maker and do not restart until the voltage is normal. Water shortage indicator light is on 1.There is no water 2.The pump is full of air 1.Press the stop button, fill with water, wait 3 minutes and press the start button to restart. When the water has reached the fill line the ice maker will restart automatically. 2.
