User Manual

Step 6

If indicator is in red with beeping noise, please take out the ice with the scoop.

Note: When the ice collecting tray is full please remove the ice immediately, Do not allow the ice

collecting tray to overfill.

Step 7

Press button to stop the machine.

Caring

1.Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning,

unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and

the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids,

gasoline or oil. Rinse thoroughly before starting.

2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use

mechanical devices or other means to accelerate the defrosting process, other than those recommended by the

manufacturer.

3. If the icemaker is reused after a long time, the water pump may not pump sufficient water due to an air block,

the deficient water indicator turns on in this case . To correct this press the START button again, then the

icemaker will work normally.

4.To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours.

5.If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not start

the system right away, wait 3 minutes, and then re-start the Ice maker.

6. Always use fresh water before starting ice production either at initial installation or after a long shut-off

period.