User Manual

Control Panel Operation

: Press it to turn unit on.

: Press it to turn unit off.

: Ice size selection (S) small, (M) medium or (L) large. (The selected mode will stay as selected unless

changed or there is a power failure) The default setting is medium.

: This light will come on with a long noise 'DI' noise. You will need to add water and press the 'STOP'

then the 'START' button to restart the Ice maker.

: This light will come on with a beeping noise when the ice has reached the maximum capacity of the

storage cabinet. Press button then press button to restart the Ice maker after some of the ice has

been taken away.

Operating Instructions

Step 1.

Open the lid and fill the water reservoir with water.

Note: Make sure the water level in the water reservoir is not over the Ice collecting tray.

Step 2.

Connect to the power.

Step 3.

Select desired ice cube size by pressing

Note: Please select the (S) when ambient temperature is below 15°c. When the ambient temperature

is higher than 30°C, Large ice cube sizes are recommended.

Step 4

Press button to turn unit on. The ice maker begins to work.

Note: For the first three cycles, the ice may be small and irregular in size.

Step 5

If indicator is red with 'DI' noise, then take out the basket, then add water as per step 1，then press

, at last press to restart the ice maker

Note: If no water is pumped up to the water tray over two cycles but the water in water tank is enough,

then please open the drain cap, and let several drops water runs out.