Use and Care Manual

16
10 Remove the Juice Pitcher
from under the spout. You
may close the Juice Pitcher
Lid and store juice in the
Juice Pitcher if desired.
NOTE: To do this, you’ll first need
to tip the Juice Pitcher forward
at a slight angle, so that the lid’s
large hole has some separation
from the spout, then you can slide
out the pitcher. This is the reverse
of what you did during assembly.
9 To stop juicing, press the speed
at which you are currently
juicing. To completely power
o the juicer, press the center
power button and wait for the
Sieve to stop spinning. Unplug
the unit after each use.
8 When the Pulp Basin is
completely full, it must be
emptied before continuing
juicing. See disassembly
instructions.
11 Immediately move the
No-Drip Spout cover
downward over the spout
to avoid any residual drips
onto the unit or onto the
surface below the juicer.
TIP: We recommend using your
left hand to pull the Juice Pitcher
away, while using your right hand
to swing the No-Drip Spout cover
down and over the spout opening.