User guide.
Important safeguards. Warning! To avoid the risk of serious injury, carefully read all instructions before operating your NutriBullet Juicer™. When using any electrical appliance, basic safety precautions should always be observed, including the following important information.
• Do not let the power cord touch hot surfaces, such as a stove or let it become tangled or knotted. • Always make sure the pulp basin cover is clamped securely in place (with locking handle) before the motor is turned on. Do not unfasten the clamps (locking handle) while the juicer is in operation. Always ensure the juicer is turned OFF after each use. Before disassembling, make sure the sieve has stopped rotating and the motor has completely stopped.
Ensure that the surface where the appliance operates is stable, level, clean and dry. • Remove rind from all citrus fruits before juicing. • Do not juice stone fruit unless pits of the seed stone has been removed. WARNING! Always make sure the juicer is properly and completely assembled before connecting to the power outlet and operating. • Vibration can occur during normal operation.
Contents. 03 Important safeguards 08 What’s included 09 Assembly guide 10 Assembly & use 12 15 16 Usage instructions Control dial Juicing tips 20 Disassembly 22 Care instructions 22 Replacement parts 22 How to store 23 NutriBullet Juicer™ one-year limited warranty 26 Warranty registration Thank you for purchasing the NutriBullet Juicer™.
What’s included. 8 800 WATT MOTOR BASE WITH LOCKING HANDLE PULP BASIN COVER WITH 3" FEED CHUTE FOOD PUSHER 1.
Assembly guide. food pusher 3” feed chute basin cover stainless steel sieve (inside basin) 1.
Assembly. 10 1 Place the Motor Base on a dry, level counter top. Ensure the dial is set to the "OFF" position and the unit is unplugged. 3 Align the Sieve with the motor drive coupling and push down until it clicks into place. Handle the Sieve by gripping the top edges being careful not touch the sharp teeth on the base of the Sieve. Ensure the Sieve is properly seated in place and securely inside of the Pulp Basin. 2 Place the Pulp Basin on top of the Motor Base.
5 Raise the Locking Handle and move it into the "ears" on each side of the Basin Cover. The Locking Handle should be in a vertical position and locked into place. 6 Swing the No-Drip Spout cover up vertically, so that it is no longer covering the juice spout. 8 Slightly angle the Juice Pitcher and place it under the juice spout. Align the spout with the hole in the Juice Pitcher Lid and level out the Juice Pitcher. It will fit snuggly into the spout to hold it in place.
Usage instructions. 1 12 Gather all of your desired ingredients and wash them. Prepare the ingredients to be juiced by cutting, skinning, or removing the rind, stems, or stone seeds. 2 After the juicer is fully assembled, plug the power cord into an outlet. Use the Dual-Speed Control Dial to select a speed to begin juicing. You can toggle between speeds as desired depending on the type of produce. (Refer to the chart on page 16 for recommended speeds for different types of produce).
3 While the motor is running, begin gently guiding your ingredients into the feed chute using the Food Pusher. NOTE: Do not use excess force or speed when pushing food down with the Food Pusher, as it will not allow for maximum juice yield. 4 Juice will begin to flow out of the spout and into the Juice Pitcher, while the pulp will be separated and stored in the Pulp Basin. WARNING: Never use hands/ fingers or other tools to push food down the feed chute into the Sieve.
5 When the Pulp Basin is completely full, it must be emptied before you continue juicing. See disassembly instructions. 6 Always be sure to turn the Dual-Speed Control Dial to the "OFF" position and wait for the Sieve to stop spinning before removing the Juice Pitcher from under the spout. Unplug the unit after each use. 7 Remove the Juice Pitcher from under the spout. You may close the Juice Pitcher Lid and store juice in the Juice Pitcher if desired.
Control dial. DUAL-SPEED CONTROL DIAL & JUICING SETTINGS OFF LOW HIGH OFF: Power is OFF, the juicer is not running. OFF LOW HIGH LOW: Best for juicing softer fruits and vegetables. OFF LOW HIGH HIGH: Best for harder produce like carrots and beets.
Juicing tips.
VITAMINS / NUTRIENTS source of quercetin excellent source of folate good source of vitamin C high in vitamin C, high in folate, good source of potassium high in vitamin C, good source of folate high in vitamin C excellent source of vitamin A, good source of vitamin C high in vitamin C, good source of folate good source of vitamin C, good source of vitamin A good source of vitamin C good source of vitamin C and potassium contains vitamin C, magnesium, and potassium good source of vitamin K high in vitamin A,
PROPER PRODUCE PREP FEED CHUTE Prepare fruit and veggies before inserting them into the juicer: • Never place your hand or fingers into the feed chute when it is attached to the appliance. • Properly clean produce (rinse with lukewarm water, produce wash, or water and apple cider vinegar). • Peel or remove skin as needed, and chop food items down to the right size – just small enough to fit easily into the feed chute, without having to force the pieces down with the Food Pusher.
CONSUMING JUICE & PULP NO-GO FOODS Instead of composting or throwing away the pulp left over after juicing, you can choose to consume it. See our Recipe Guide for some fun tips on what to do with the pulp. By using these creative ideas, you can enjoy pulp in a variety of delicious (and healthy) ways. Foods that should NEVER be used in this juicer: • Whether you prefer sweet or savory, you can use pulp to create some tasty treats! • For best taste,consume fresh juice and pulp within 48 hours of juicing.
Disassembly. 20 1 Ensure the unit is powered down, turned “OFF,” and unplugged. 2 Remove the pitcher from under the spout. To prevent drips use the No-Drip Spout cover to close the juice spout. 3 Unlock the Locking Handle from the Basin Cover by pulling the handle backward out of the “ears” on either side of the Basin Cover. Move the handle down. 4 Remove the Pulp Basin from the Motor Base by pulling upwards with the Basin Cover and Sieve still in place, and take it directly to your sink.
5 Remove the Food Pusher by lifting it out of the feed chute. 6 Lift the Basin Cover vertically off of the Pulp Basin and remove any pulp from the inside of the cover. You may use the flat end of the Cleaning Brush to scrape pulp off of the cover. 7 Gently lift the Sieve vertically out of the center of the Pulp Basin. Clean the Sieve right away (see care instructions). 8 Empty the Pulp Basin.
Care instructions. 1 2 3 TIP: Always clean the Sieve as soon as possible after juicing using the Cleaning Brush. If allowed to sit, pulp will dry on the Sieve and it will become more difficult to scrub blocked holes. If this happens, be sure to allow the Sieve to soak in hot water for 30 minutes. Always ensure the Motor Base is unplugged before you begin assembly, disassembly, cleaning or storage of the unit. Once the Pulp Basin is emptied, rinse all parts under running water.
NutriBullet Juicer™ one-year limited warranty. LIMITED WARRANTY FOR NUTRIBULLET ® NutriBullet's limited warranty obligations are confined to the terms set forth below: NutriBullet, LLC and Capital Brands Distribution, LLC (together, “NutriBullet”) warrants this NutriBullet® against defects in materials and workmanship for a period of one year from the date of original retail purchase.
send your product for limited warranty service please make sure to keep a copy of all relevant documents for your files (receipt, etc.). It is always recommended to purchase product insurance and tracking services when sending your product for service. Remember, shipping and processing fees will be incurred by you and are not covered by the one-year limited warranty.
AND CONDITIONS, WHETHER ORAL OR WRITTEN, EXPRESS OR IMPLIED. NUTRIBULLET SPECIFICALLY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IF NUTRIBULLET CANNOT LAWFULLY DISCLAIM IMPLIED WARRANTIES UNDER THIS LIMITED WARRANTY, ALL SUCH WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
Warranty registration. Please visit nutribullet.com/ warranty-registration or call 1 (800) 523-5993 to register your new NutriBullet Juicer™. You will be asked to enter the Serial Number* of your product, along with the purchase date and place of purchase. The registration will enable us to contact you in the unlikely event of product safety notification. By registering your product you acknowledge you have read the instructions and understood the warnings as set forth in the accompanying instructions.
1 (800) 523-5993 | nutribullet.com NUTRIBULLET® is the registered trademark of C APBRAN HOLDINGS, LLC Copyright © 2020 CAPBRAN HOLDINGS, LLC. Distributed by CAPITAL BRANDS DISTRIBUTION, LLC. LOS ANGELES, CA 90025 USA All Rights Reserved. MADE IN CHINA Illustrations may differ from the actual product. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice.
