Warranty

13
Steam and splatters can escape
through the vented lid, potentially
causing scalding and/or burns.
NEVER blend hot liquids in your
pitcher without the pitcher lid
and lid cap attached. The lid cap
is ventilated to allow steam and
pressure to release, while guarding
against excess splashing.
When blending hot liquids, add
liquid and solid ingredients to your
pitcher below their respective
MAX lines. Attach the pitcher lid
with the lid cap inserted. Press
the POWER icon, then begin
blending on the LOW setting. Once
ingredients are integrated and
the mixture is level (no splashing),
increase speed as needed.
Getting started.
Pitcher assembly
& use.
PLEASE KEEP
THESE IMPORTANT
SAFEGUARDS IN
MIND WHEN USING
THE APPLIANCE:
• Make sure the base is plugged in
for use.
• DO NOT attempt to operate the
blender pitcher on the appliance
without attaching the pitcher lid and
vented lid cap.
• Never run the appliance while empty.
• Appliance accessories are not
intended to be used in the microwave
as it may damage the accessories.
• Never leave the appliance
unattended while in use.
Use extra caution when
blending hot liquids in
the pitcher.
Place the pitcher onto the
motor base — handle facing
to the right of the blending
control panel, never towards
the back — and gently twist
clockwise so it locks in place.
When you hear the click, it’s
locked and ready to blend.
NOTE: If you are left-handed, place
the handle facing towards the center
of the blending control panel and
twist clockwise.
3
WARNING!
4
Add the ingredients to the
pitcher, making sure they do
not exceed the MAX line.
NOTE: The blending pitcher is
marked with two MAX lines: one for
solid ingredients (higher line) and
one for liquids (lower line). When
filling the blender, make sure your
ingredients do not exceed their
respective MAX lines.
1 Review all warning and
caution statements in the
Important Safeguards
section (pg 3-7) and on
the previous page before
proceeding to Step 2.
2 Place the motor base on
a clean, dry, level surface
such as a counter or table.
5
Place the pitcher lid with
vented lid cap attached on
the pitcher, making sure it’s
aligned to the handle.
12