Use and Care Manual

76
twist the Extractor Blade on to the Cup tightly, liquids can leak out and get into
the base and stick to the activator buttons.
• To avoid risk of injury, NEVER use your hands or utensils to clean the White
Actuator Tabs while the NutriBullet® is plugged in.
• Do not remove the rubber or plastic liners inside the Power Base.
• Use a sponge or dish cloth dampened with warm soapy water to wipe down the
inside and outside of the Power Base until clean.
• Pay particular attention to the white Actuator Tabs on the inside of the Power
Base to loosen any sticky debris from drips and spills. If necessary, you may use a
small brush to scrub the area to ensure it is kept clean.
EXTRACTOR BLADES:
• DO NOT REMOVE THE GASKET as this will permanently damage the Extractor Blade
and cause leakage. If after washing as indicated above additional disinfecting
is desired, you may rinse with a 10% vinegar/water solution or with lemon juice.
If, over time, the gasket becomes loose or damaged, you may order a new
Extractor Blade at NutriLiving.com or contact Customer Service.
• Dry the Extractor Blade completely. It is helpful to turn the blade on its side in your
dish drainer to ensure BOTH SIDES of the Extractor Blade are completely dried.
NUTRIBULLET® CUPS, LIDS AND LIP RINGS:
• These items are all TOP RACK dishwasher safe. We recommend rinsing them and
giving them a quick brush with a dish brush to remove any dried debris before
washing them in the dishwasher. NEVER use the sanitize cycle to wash the Cups
as this may warp the plastic.
• Regularly check the 3 tabs on the side of the Cup (cracking, crazing,
breakage or rounding). If damaged, replace immediately to prevent possible
personal injury.
• NEVER USE A CUP WITH A BROKEN TAB AS DOING SO MAY CAUSE THE CUP AND
POWER BASE TO SEPARATE EXPOSING THE BLADE ASSEMBLY!
STUBBORN CLEAN UP
• If ingredients dry inside the NutriBullet® Cup, make your cleanup a snap by
filling the Cup about 2/3 full with room temperature (21°C/70°F or less) water
and screw on the Extractor Blade. Place the Cup/Extractor Blade assembly on
the NutriBullet® Power Base for about 20-30 seconds. This will loosen the stuck
ingredients, and with a light scrub and rinse, you’ll be all finished.
SAVE THESE INSTRUCTIONS
IF YOU HAVE ANY COMMENTS, QUESTIONS OR CONCERNS,
PLEASE GO TO NUTRILIVING.COM
OR CALL CUSTOMER SERVICE AT: 1-800-523-5993.
Banana Bread Protein Smoothie | To Get The Recipe Visit NutriLiving.com
CHECK OUT
NUTRILIVING.COM
FOR RECIPES, ADVICE, Q&A
FROM OUR NUTRIBULLET
REGISTERED DIETITIANS!