Use and Care Manual

1716
SHAKE
TECHNIQUE
If you pack the ingredients down inside the Cup, or do not add enough
water, the results can increase the density of the mixture. This makes it hard
for the ingredients toward the top of the Cup to make it down to the Blade. If
some of your ingredients are having a hard time making it down to the Blade,
simply use the Shake Technique.
1
1
2
2
PULSE
TECHNIQUE
Because the NutriBullet’s motor is so powerful, it emulsifies the ingredients
when you blend. That is why when you want to make foods such as chunky
salsa, or coarse chopped onions, the Pulse technique is key. Pulsing takes a
tiny bit of getting used to, but once you get a feel for it, you’ll be a Pro in no
time!
To Pulse, you simply press down on the Cup very quickly and immediately
release. For foods that you want coarsely chopped, a quick tap on the top of
the Cup is all you need. Then let the Blade come to a complete stop and tap
again until you get the consistency you desire.
THE SECRET: The trick to successful Pulsing is to make sure that the machine
doesn’t accidentally slip into Lock On mode. To avoid this, simply use your
other hand to apply counter-clockwise pressure on the Cup as you Pulse.
To start, hold the cup at the base and apply
counter-clockwise pressure to it, to keep it from
locking on.
With your other hand, tap the top of the Cup and
immediately release. Continue Pulsing until you get
the consistency you want.
Remove the Cup and Blade assembly from the
Power Base.
With the Cup and Blade assembly in hand, shake
it like a cocktail shaker. Then put it back on the
Power Base and operate as usual.
TAP
TECHNIQUE
For really stubborn ingredients that are clinging to the side of the Cup, simply
use the Tap Technique.
Remove the Cup and Blade assembly from the Power
Base.
Tap the Blade side of the Cup/Blade assembly on the
counter with just enough force to dislodge ingredients
from the sides of the Cup. Be careful not to tap too hard
to avoid damaging the Cup.
Return the Cup and Blade assembly to the Power Base
and resume blending. Repeat if necessary.
1
2
3
TIPS FOR USING
YOUR NUTRIBULLET
CAUTION: Do not run the Power Base in excess of 1 minute per interval. Do not run the Power
Base for more than three 1-minute intervals without allowing it to cool for 2-3 minutes after
the third extraction. Running the motor for more than 1 minute consecutively in any interval
may result in personal injury, property damage or permanent damage to the Power Base.