Use and Care Manual

2423
For replacement
parts.
Visit nutribullet.com/shop/
accessories or call customer
service at 1 [phone].
EXTRACTOR BLADES:
• Rinse the Rapid
Extractor Blade with
warm, soapy water.
• Use a small brush or sponge
dampened in soapy water to
remove any residue on the
Rapid Extractor Blade.
NOTE: It’s best to clean the Rapid
Extractor Blade immediately after
use to avoid the buildup of residue.
MOTOR BASE:
• Use a sponge or dishcloth
dampened with soapy water
to clean the surface of the
Motor Base.
• Use a small brush to scrub
the actuator system of the
Motor Base.
CUPS & TO-GO LIDS:
• Cups and To-Go Lids are
dishwasher-safe. Rinse or
scrub beforehand to remove
any debris.
WARNING! NEVER place
the Rapid Extractor Blade,
Cups or To-Go Lids on the
bottom rack or use the
heat/sanitize cycle of your
dishwasher when cleaning,
as this may cause warping
and possible safety hazards.
STUCK INGREDIENTS:
• For stuck ingredients on
Cups or Rapid Extractor
Blades, fill with room
temperature water to the
MAX line and add 1-2 drops
of dish soap.
• Twist on the Rapid Extractor
Blade and blend for 20-30
seconds to loosen debris
enough to scrub away with
soap and water.
STORAGE:
• Always store your
nutribullet
®
Ultra upright
without any objects placed
on top of it. Store accessories
in a safe place until use.
1 Once blending is complete,
make sure your nutribullet
®
Ultra Motor Base is powered
o and unplugged from
its outlet.
2 Detach the nutribullet
®
Cup
and Rapid Extractor Blade
from the Motor Base.
3 Clean the individual
components as follows:
Cleaning: #1
Cleaning #2