User Manual

8
SAFETY WARNINGS: EXTRACTING FOR NUTRIBLASTS
• THE NUTRIBULLET SELECT IS PROGRAMMED TO RUN FOR 1 MINUTE IN
EACH SELECTED MODE.
• IF THE POWER DOES NOT SHUT OFF AFTER 1 MINUTE DURING ANY
SELECTED MODE, STOP IT MANUALLY BY TURNING THE KNOB TO OFF OR
SIMPLY TWIST THE VESSEL TO THE RIGHT AND LIFT CUP OFF POWER BASE.
• TO TURN OFF THE MACHINE AT ANY TIME DURING THE CYCLE (G BUTTON
WILL BE GREEN), TURN THE POWER KNOB TO THE UPRIGHT OFF POSITION
OR SIMPLY PUSH DOWN ON THE CUP AND TWIST TO THE RIGHT AND LIFT
THE CUP OFF THE POWER BASE, WHICH WILL TURN OFF THE UNIT. THE
LIGHT WILL STOP GLOWING, AND THE MOTOR WILL STOP, SIGNIFYING THAT
THE POWER IS OFF. ALWAYS ALLOW THE MOTOR TO STOP COMPLETELY
BEFORE REMOVING THE CUP/ PRECISION EXTRACTOR BLADE. ALWAYS
UNPLUG THE POWER BASE UPON COMPLETION OF USE.
• DO NOT TOUCH COUPLING GEAR DIRECTLY WITH HANDS AFTER USE!
THE COUPLING GEAR IN PRECISION EXTRACTOR BLADE BASE AND
POWER BASE WILL BE HOT!
• DO NOT RUN IN ANY MODE FOR MORE THAN 1 MINUTE INTERVALS.
• AFTER INITIAL CYCLE, ALLOW POWER BASE TO SHUT OFF COMPLETELY
AND WAIT FOR 15 SECONDS BEFORE STARTING ANOTHER CYCLE.
• DO NOT RUN FOR MORE THAN 3 CONSECUTIVE 1 MINUTE INTERVALS
WITHOUT ALLOWING THE POWER BASE TO COOL TO PREVENT
OVERHEATING AND ALLOW INGREDIENTS TO SETTLE FOR 2-3 MINUTES
AFTER THE 3RD EXTRACTION CYCLE.
• POWER BASE IS EQUIPPED WITH AN INTERNAL THERMAL BREAKER THAT
SHUTS OFF THE POWER BASE IF THE UNIT OVERHEATS.
• IF THE POWER BASE OVERHEATS AND SHUTS OFF, UNPLUG THE POWER
BASE AND LET IT COOL FOR AN HOUR OR MORE BEFORE ATTEMPTING TO USE
IT AGAIN. POWER BASE WILL RESET WHEN THE UNIT IS POWERED OFF AND
THE THERMAL BREAKER HAS COOLED DOWN SUFFICIENTLY.
• ALLOW MACHINE TO COOL DOWN FOR 10 MIN AFTER 4-5 CYCLES TO
PREVENT OVERHEATING AND DAMAGING THE UNIT.
• To prevent leakage, always align and hand-tighten the precision extractor
blade to the vessel or cup prior to inverting it and placing the assembly on to
the motor base.
• TO TURN ON THE NUTRIBULLET SELECT: Choose the desired Mode
by turning the dial to align with the desired mode as indicated on the
NutriBullet Select Power Base. Press the center button. The light will glow
GREEN and the motor will cycle up.