User Manual

11
STUBBORN CLEANUP
If ingredients dry inside the NutriBullet, make your cleanup a snap by filling the cup
about
 full with warm (not hot) soapy water and screw on the Blade. Place the cup
assembly on the NutriBullet, Power Base for about 20-30 seconds. That will loosen
the stuck ingredients, and with a light scrub, you’ll be all done.
MAINTENANCE
For the most part the Power Base doesn’t really get dirty, but if you neglect
to twist the blade on to the cup tightly, liquids can leak out and get into the
base and activator buttons.
Here’s how to clean it up.
Step 1: The most important thing is to UNPLUG the Power Base before cleaning!
Step 2: Make sure the blade is not attached to the Power Base.
Step 3: Use a damp cloth to wipe down the inside and outside of the Power Base.
IN THE EVENT OF SPILL, CHECK THE UNDERSIDE OF THE BASE. IF LIQUID
FOOD IS EXITING THE VENTS, DO NOT USE UNTIL INSPECTED BY A CERTIFIED
ELECTRICIAN AS THE MOTOR HAS LIKELY BEEN COVERED IN FOOD, POTENTIALLY
GIVING USER AN ELECTRIC SHOCK.
Never put your hands or utensils near the moving blade and never use your hands
or utensils to press the activator buttons down while the Power Base is plugged in.
WARNING:
DO NOT WASH THE BLADES IN THE DISHWASHER. THE NUTRIBULLET
CUP AND BLADE SHOULD NOT BE IMMERSED IN BOILING WATER FOR ANY
REASON AS THIS WILL WARP THE PLASTIC AND DAMAGE THE
GASKETS.