Installation Manual
1615
Extracting for souperblasts.
Plug the motor base into an
electrical outlet. Press the
power button located 90˚ to
the left side of the G-Button,
to turn the machine on. Next,
place the pitcher blade-
side-down onto the motor
base. This will activate the
NutriBullet
®
Rx’s SMART
Technology function, causing
the G-Button at the front of
the unit to glow GREEN.
3
4
Press the GREEN G-Button
down for 2 seconds until it
glows ORANGE. This will
indicate that souperblast
mode has begun. The unit
will run in souperblast mode
for about 7 minutes before
automatically turning o,
causing the ingredients
inside the souperblast
pitcher to heat up to about
70 degrees Celsius/150
degrees Fahrenheit. The unit
is programmed to slow down
twice during the 7-minute
cycle to allow ingredients
to settle for improved
processing. This is normal.
Do not repeat souperblast
mode for the same hot soup.
If more heat is required,
place the contents in a
microwave-safe container
and continue heating to
desired temperature. To
make a new soup, empty
old contents, add new
ingredients and wait 1 full
minute before returning
the vessel to the motor
base to start a new SMART
Technology cycle. Do not
repeat more than 2 cycles
in souperblast mode resting
1 minute between cycles.
After 2 consecutive cycles,
allow the NutriBullet
®
Rx
motor base and souperblast
accessories to cool o for 30-
60 min. Depress the power
button upon completion.
1
Twist the extractor blade
onto the souperblast pitcher.
2 Add ingredients into the
souperblast pitcher and
securely attach the vented,
2-piece lid souperblast
pitcher lid.
After souperblast mode,
the SOUPERBLAST PITCHER
SURFACE, BLADES AND
COUPLING GEAR WILL
BE HOT! DO NOT TOUCH
DIRECTLY WITH HANDS!
Always use heat resistant
pads to grasp the handle
and to support the bottom
of the souperblast pitcher.
IF YOU DESIRE SOUP TO BE
HOTTER OR YOU WISH TO
RE-HEAT SOUP, TRANSFER
FIRST TO AN APPROPRIATE
MICROWAVE SAFE
CONTAINER OR STOVE TOP
POT AND HEAT SEPARATELY
—DO NOT REHEAT IN THE
NutriBullet
®
Rx.
• TO TURN OFF THE MACHINE
AT ANYTIME DURING THE
SOUPERBLAST CYCLE (G
BUTTON WILL BE ORANGE),
press the power o button,
located 90˚ to the left side
of the G-Button or lift the
souperblast pitcher o the
motor base.
WARNING!
16