Installation Manual

1413
How it works.
Extracting for smoothies.
* DO NOT RUN SOUPERBLAST MODE WITH ANY OF THE
BLENDING CUPS ONLY USE THE VENTED SOUPERBLAST
PITCHER READ ALL SAFETY INSTRUCTIONS FIRST!
Plug the motor base into an
electrical outlet. Press the
power button, located 90˚ to
the left side of the G-Button,
to turn the machine on. The
power button light will glow
BLUE, signifying power.
Next, place the cup blade-
side-down onto the motor
3
4
base. This will activate the
NutriBullet
®
Rx’s SMART
Technology function, causing
the G-Button at the front
of the unit to glow GREEN,
and initiating the 1-minute
extraction cycle.
When the cycle has
completed and the GREEN
light has turned o, turn o
the unit by depressing the
power button, located 90˚ to
the left side of the G-Button.
The BLUE light will stop
glowing, signifying the power
is o.
1 Add ingredients into one of
the cups.
2 Fill with liquid up to the MAX
Line. Then, twist the extractor
blade onto the cup and
tighten by hand to make sure
the vessel is sealed.
o. When the power o button
is pressed, the BLUE light will
turn o and the blade will stop
spinning. Always press the power
o button upon completion
of processing.
• NOTE: If at any time the
G-Button is pushed for 2
seconds, the button will
turn ORANGE and initiate
souperblast mode.
TO TURN OFF THE MACHINE
AT ANYTIME DURING
THE SMOOTHIE CYCLE
(GBUTTON WILL BE GREEN),
press the power button,
located 90˚ to the left side of
the G-Button or lift the cup o
the motor base.
NOTE: You can remove the cup
at any time during the blending
cycle by simply lifting the cup
o of the motor base. If more
extraction is required, lift the
cup o of the motor base, wait
15 seconds, then return it back
onto the motor base to start
another SMART Technology
cycle. Do not repeat more than
3 consecutive cycles resting 15
seconds between cycles. If you
press the GREEN G-Button for
2 seconds and the light turns
ORANGE, you have switched
in souperblast mode. Simply
lift the cup o the motor base
at any time to exit this mode or
press the power button, located
90˚ to the left side of the
G-Button. When the vessel is
removed from the motor base,
only the G-Button light will turn
WARNING!