Quick Start Manual

Connecting the Low Voltage Wiring
Ideally, you will run the wiring and make all the wiring
connections after you have completed the tubing system. Of
course, the inlet wiring must be run at the time the inlet
tubing is threaded through the walls.
Run the low voltage wiring along the trunk line; at
approximately 12˝-18˝ intervals, use electrical tape to
secure the wire to the tubing. Then, run wiring along the
branch lines from the inlet lines to the trunk line. Also secure
this wiring with electrical tape.
At the joint of the inlet line and the branch line, make a
two-wire connection. Use wire nuts to make the connections
and insulate each connection with electrical tape.
At the junction of every branch line and the trunk line, cut the
trunk line wire and connect it to the branch line wire.
Connect this wiring in groups of 3–one branch wire, one
in-coming trunk line wire and one outgoing trunk line wire.
Insulate all wire connections with electrical tape.
Complete all wiring connections up to the power unit’s intake
access hole. You will make this connection when you mount
and connect the power unit. If, for some reason, you want to
connect the wire as you go along, make the same two-wire
and three-wire connections where required.
Ass embling a Basement Trunk Line
Basically, the tubing network is assemble the same way for
a basement installation. Begin the trunk line at the farthest
inlet line from the power unit. Measure and cut the inlet
tubing to the length required to align the trunk line with the
joists or ceiling. Cement the inlet tubing and connect at 90°
elbow. Then, run the trunk line until you reach a branch line
junction point.
29