Instructions / Assembly

7
MODEL CF361 & CF361F (For Use with
CI370 and 360 Inlets)
3. Refer to Figure 10. Nail bracket to the side of the stud
so that the front edge of the bracket is flush to the
front of the stud. (The bracket may also be nailed to
the front edge of the stud. See face mounting
illustrated. For face mounting, use locating tabs on
bracket for proper alignment.)
4. Refer to Figure 11. Remove cardboard from plaster
guard frame. Using four (4) provided screws, attach
the appropriate flanged fitting and inlet seal to back
of inlet.
5. Replace cardboard in plaster guard frame.
MODEL CF329 (For Use
with 330 Inlets)
6. When using Model CF329, glue
elbow to mounting plate. Attach
to stud as shown in Figure 12.
SIDE
MOUNTING
FACE
MOUNTING
MODEL CF361 & CF361F
2
3
/8"
1
13
/16"
FIGURE 10
MODEL V144
FIGURE 12
INSTALLATION IN
NEW CONSTRUCTION
WALL INLET ROUGH-IN
Once the locations for the wall inlets have been determined, mount all inlet brackets.
1. Choose the appropriate mounting bracket for the inlet being installed. (See chart)
2. To locate a bracket on a wall stud, measure approximately 18" up from finished floor level. (Height may vary
according to individual preference.)
Rough-In Series
395 396-1 396-3 CI3301RK CI3303RK CF329 CF361 CF361F CI395RK
330 X X X
360 X X X X X
CI335 X
CI358 Rough-in and wall valve sold together
CI370 X X X X X
CI390 X
CI395 X
CI398 X X X
Wall Valve Series
FIGURE 11