Installation Guide

Page 4

MODELS QTXEN080 • QTXEN110

SERVICE PARTS

99045487B

Key No. Part No. Description

1 97016466 Housing

2 97016450 Duct Connector-6”

3 98010102 Wiring Plate

4 99170245 Screw, #8-18 X .375

5 97018010 Wire Panel/Harness Assembly

6 97020047 Blower Assembly (QTXEN080)

97020048 Blower Assembly (QTXEN110)

7 99140199 Grille Spring (2 req’d)

8 97017622 Grille Assembly (includes key no. 7)

9 97018014 Spacer (2 supplied)

10 QTNHB1 Hanger Bar Kit

11 99420665 Thumbscrew, #8-18 x .375

Order service parts by “Part No.” - not by “Key No.”

SERVICE NOTE To remove Blower Assembly: Unplug motor.

Remove thumbscrew (11) from motor plate flange. Find the

single TAB on the motor plate (located next to the recepta-

cle). Push up near motor plate tab while pushing out on side

of housing. Or insert a straight-blade screwdriver into slot in

housing (next to tab) and twist screwdriver.

INSTALL GRILLE

6. Attach grille

to housing.

Squeeze grille

springs and insert

them into slots on

each side of hous-

ing.

7. Push grille

against

ceiling.

5. Finish ceiling.

Install ceiling material. Cut out around housing.

4. Connect electrical wiring.

Run 120 VAC house wiring to installation location. Use

proper UL approved connector to secure house wiring to

wiring plate. Connect wires as shown in wiring diagrams.

CONNECT WIRING

Replacement parts can

be ordered on our web-

site. Please visit us at