Instructions / Assembly

-8-
6. LIGHT BULBS
This range hood requires two UL approved halogen bulbs (JC type, 12 V, 20 W, G4-base), included.
To replace bulbs:
1. Carefully insert the blade of a small flat blade screwdriver between light cover and rim and
gently pry out light cover from light assembly.
WARNING
Make sure power is switched off at service panel before carrying out any operation on the hood.
!
HD0399
WARNING
In order to prevent the risk of personal injury, the halogen lamps must cool down
before removing them.
!
2. Remove light cover from light assembly and set aside.
3. Replace bulb with a new JC type, 12 V, 20 W Max, G4 base halogen bulb.
4. To reinstall the light cover, insert the 3 light cover tabs in the light assembly slots and gently
push until secure.
CAUTION
Do not touch replacement bulb with bare hands!
HD0401
HD0400
CAUTION
Take care not to damage the hood finish while using the screwdriver.
LIGHT ASSEMBLY SLOTS