Instructions / Assembly

2. Remove both electrical box cover retaining screws. Remove cover and set aside with

screws. Turn the hood over and punch out the wiring knock-out located on TOP of the

unit and install the wire clamp (included).

1. Remove the shutoff plate 10 retaining screws. Set the screws aside and discard the

shutoff plate.

2. Mount the 6” round adapter/damper on top of the hood, using the 10 screws

previously removed.

2. Mount the 3

⁄4” x 10” adapter/damper on top of the hood, using the 10 screws

previously removed.

3. PREPARE THE HOOD

SCREW LOCATIONS

HO0047

3.2 VERTICAL DISCHARGE ONLY

-5-

HJ0001

6” ROUND DUCT INSTALLATION

HJ0003

3¼” X 10” DUCT INSTALLATION

HO0051

1. Lay the hood on its top on a table. Use a

piece of cardboard to avoid damaging the

table or the hood. Slide the main grease

cup out and set aside. Remove the bottom

panel 7 retaining screws. Set bottom panel

and screws aside.

SCREW LOCATIONS

HO0046

3.1 ALL INSTALLATIONS

HO0173

GREASE CUP