Instructions / Assembly

VERTICAL DISCHARGE
USING 6” ROUND DUCT
VERTICAL DISCHARGE
USING 3¼” X 10” DUCT
HORIZONTAL DISCHARGE
USING 3¼” X 10” DUCT
-3-
1. INSTALL DUCTWORK
Choose where the ductwork will run between the hood and the outside.
A straight, short duct run will allow the hood to perform most efficiently.
Long duct runs and elbows will reduce the performance of the hood. Use as few of them as possible.
Install proper-sized ductwork, elbow(s) and roof or wall cap for the type of discharge chosen. Use 2’’ metal foil duct tape to seal joints.
Please take note this manual uses the following symbols to emphasize particular information:
NOTE: Indicates supplementary information needed to fully complete an instruction.
ABOUT THIS MANUAL
WARNING
Identifies an instruction which, if not followed, might cause serious personal injuries including possibility of death.
CAUTION
Denotes an instruction which, if not followed, may severely damage the unit and/or its components.
HH0144A
ROOF CAP
WALL CAP
ADJUSTABLE
ELBOW
ADAPTER/
DAMPER
26” MINIMUM ABOVE
COOKING SURFACE
(28” FOR GAS RANGE)
HH0145A
WALL CAP
ADAPTER/DAMPER
26” MINIMUM ABOVE
COOKING SURFACE
(28” FOR GAS RANGE)
HH0146A
ROOF CAP
WALL CAP
ADJUSTABLE
ELBOW
ADAPTER/
DAMPER
EAVES CAP
26” MINIMUM ABOVE
COOKING SURFACE
(28” FOR GAS RANGE)
NOTE: We recommend to install the hood at a minimum of 26” from an electric range and at 28” from a gas range. For optimal
performance, the hood should not be installed more than 30” from cooking surface.
!
TABLE OF CONTENTS
1. INSTALL DUCTWORK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
2. PREPARE THE INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
3. P
REPARE THE HOOD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-6
4. INSTALL THE HOOD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
5. CONNECT WIRING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
6. LIGHT BULBS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
7. C
LEANING AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9-10
8. OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
9. WIRING DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
10. S
ERVICE PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
11. WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12