ADA Wiring Instructions

BLACK WIRE
A
B
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
RED WIRE
FROM 14/3 CABLE
A Cut the BLACK wire that is connected to motor switch and light switch.
B Cap off the BLACk wire connected to the light switch terminal. Connect the RED
wire from 14/3 cable to the BLACK wire from the motor switch, using an appropriate
wire nut.
RED WIRE CONNECTION
Once all the connections are done, finalize the installation by reversing steps  to  on first page.
NOTE: Be careful while reinstalling wiring cover to the hood.
CAUTION
Ensure both tabs on inner top of hood are engaged in their corresponding slots in wiring cover. Also, take care not
to pinch wires while reinstalling wiring cover.
SCREW
TABS ON INNER
TOP OF HOOD
ENGAGED IN
WIRING COVER
SLOTS.
3
Broan Series: BKSH and CRSH
NuTone Series: NKSH
Venmar Bistro Series: VBLSH
THIS PROCEDURE APPLIES TO THE FOLLOWING RANGE HOOD SERIES