Manualshelf

Quick Start Manual

ManualsBrandsNuTone ManualsAppliancesNuTone LA203WH
123
CHANGING THE SECURITY CODE
ON CHIME RECEIVER
To use the LA-203RWH Chime Receiver with your NuTone
Wireless Chime, set code in this Chime Receiver to match
code set in your Pushbutton.
Here's how:
1. Remove cover of Pushbutton by inserting screwdriver in
the slot at the bottom of the Pushbutton and then gently
rock the Pushbutton cover apart from the base.
(Figure 1)
Locate vertical row of black jumpers on right side of
Pushbutton.
(Figure 3 Detail)
2. Remove the screw from the access cover on back of
Chime Receiver, then remove cover.
(Figure 2)
3. Set the code switches in the Chime Receiver to match the
black jumpers in the Pushbutton. If a black jumper is in
place, then the corresponding switch on the Chime
Receiver must be set in the "ON" position.
(Figure 3)
For example: if jumper #1 is in place, code switch
#1 should be in the ON position.
4. After setting the switches, replace the cover and screw on
back of Chime Receiver.
5. Replace Pushbutton cover.
Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in China, Rev. 4/07 Part No. 88299
If you should encounter a problem.
PROBLEM
1. Chime does not sound.
• Check position of battery (+/–) in
Pushbutton.
•
Make sure Pushbutton is not located on a
m
etal surface.
•
Check that outlet on Chime Receiver has
power.
• Check Pushbutton and Chime codes.
These codes must match.
2. Chime is activated by
a
nother wireless device.
•
Change the security code
i
n the Pushbutton and Chime Receiver.
These codes must match.
(See detailed instructions below.)
SOLUTION
INSTALLATION &
OPERATING INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Plug-in
Door Chime Receiver
MODEL:
LA-203RWH
For use with these NuTone wireless products:
LA-203WH, LA-205WH, LA-206WH, LA-206TWH,
LA-207TWH (sold separately)
NuTone
FIGURE 3
FIGURE 2
FIGURE 1
1 2 3 4 5 6
ON
PLUG-IN
CHIME RECEIVER
REMOVE SCREW
AND COVER FROM
BACK OF CHIME
RECEIVER
No electrical wiring needed!
To install:
1. Simply plug chime receiver into any standard electrical
wall outlet within 100 feet of Pushbutton.
(Chime is powered by household current.)
2. Chime will sound when Pushbutton is pressed.
NOTE: Chime Receiver will not work alone.
TOP
P.C.
BOARD
BATTERY
LOCATION
SECURITY
CODE
SETTING
EXAMPLE: CHANGING CODE SETTING
SET 1, 3 & 6
SWITCHES
TO “ON”
SLOT
T
O OPEN
COVER
“PUSH”
T
O REGISTER THIS PRODUCT
, VISIT WWW
.NUT
ONE.COM

Summary of content (3 pages)