Warranty
ASSEMBLY & WIRING INSTRUCTIONS
TROUBLESHOOTING
9
1. Entire system does not work –
• Make sure transformer is plugged into a working 120 volt wall outlet.
• If wall outlet is switched, make sure it is turned on.
• Make sure the branch circuit breaker is not tripped.
• If transformer is so equipped, make sure its power switch is turned on and timers are properly
programmed.
• Make sure LED and Vaporizer circuits are connected to the transformer.
• If the system is equipped with a photocell sensor, make sure it’s located away from bushes, other
obstructions and away from artificial light sources.
2. Vaporizer or LED light of individual fixtures
flicker or do not work -
• Make sure the wire adapter in each connector is installed and properly sized for the cable in use.
• Make sure the connector locking ring is fully tightened.
• Make sure fixture wires are completely inserted into the connector
3. Repellent not working -
• Make sure cartridge is properly installed and undamaged.
• Make sure cartridges contain repellent.
• Make sure top and bottom vents of the fixture are unobstructed.
• Make sure the fixture has power. Green LED will be lit when the repellent system is on.
Broan-NuTone LLC
926 W. State Street
Hartford, WI 53027
IN U.S.A. CALL:
Customer Service:
1-888-336-3948
IN CANADA CALL:
1-877-896-1119
Technical Support:
1-888-336-6151