Warranty

ASSEMBLY & WIRING INSTRUCTIONS
WIRING
7
Connect wiring for light circuit
1 ] Place a second continuous length of landscaping cable between all fixtures and the power supply.
Label or color code this cable as the LED LIGHT circuit.
2 ] Make electrical connections at each ground stake using connectors and adapter provided. Follow
Step 2 instructions under “Connect wiring for repellent vaporizer circuit”.
3 ] Locate wire from the fixture marked LED LIGHT. Insert the tinned ends into openings on upper
half of the connector. Make sure they are completely inserted and secure. Apply dielectric grease.
4 ] Repeat this step for each fixture to complete the LED LIGHT circuit.
Test light and repellent circuits prior to cable
burial
1 ] Before landscape cables are buried, temporarily connect each circuit to the power supply and
check for proper operation of each fixture.
2 ] LIGHTING CIRCUIT - The LED landscape lighting will light when this circuit is operating correctly.
3 ] REPELLENT CIRCUIT - The green LED will light when repellent is operational.
Bury cable and connectors
1 ] Backfill around the ground stakes and tamp soil firmly after cables are buried
2 ] National Electrical Code states burial depth of the wiring should not be more than 6” below grade
surface. Check local codes to ensure compliance with regulations