Installation Guide

3 ] Set Repellent to turn on at dark via Solar Sensor, stay on for 1-12

hours (cancels out Light clock settings)

• Press MODE until, appears for 3 seconds, Repellent and

Solar Sensor indicators glow; use + or - to adjust number of hours

(1-12) for repellent to remain on after dusk.

• Depressing and holding down the + or- button will cause time to

scroll forward or backward. Release button to stop the scrolling.

• Press MODE, until appears or wait 3 seconds to close

“Repellent via Sensor”

4 ] Set Light “On” and “Off” time via clock

• Press MODE until, appears for 3 seconds, Clock and Light

indicators glow; use + or - to adjust hours for light on, noting AM

and PM indicators

• Press MODE, Clock and Light indicators glow; use + or - to adjust

minutes for light on

• Press MODE until appears for 3 seconds, Clock and

Repellent indicators glow; use + or - to adjust hours for light off

• Press MODE, Clock and Light indicators glow; use + or - to adjust

minutes for light off

• Depressing and holding down the + or- button will cause time to

scroll forward or backward. Release button to stop the scrolling.

• Press MODE until appears or wait 3 seconds to close “Set

Light Time”

5 ] Set Light to turn on at dark via Solar Sensor, stay on for 1-12

hours (cancels out Light clock settings)

• Press MODE until, appears for 3 seconds, Light and Solar

Sensor indicators glow; use + or- to adjust number of hours (1-12)

for light to remain on after dusk

• Depressing and holding down the + or- button will cause time to

scroll forward or backwards. Release button to stop the scrolling.

• Press MODE, until appears or wait 3 seconds to close

“Light via Sensor”

6 ] Close timer controller cover after programming has been

completed.