Installation Guide

3
LED LIGHT CIRCUIT
VAPORIZER CIRCUIT
120 VAC 60 HZ
PRIMARY INPUT
120 VAC 60 HZ
PRIMARY INPUT
POWER
SUPPLY
POWER
SUPPLY
12 VAC OUTPUT
12 VAC OUTPUT
WARNING
To reduce the risk of fire, electric shock, or injury to persons,
observe the following:
• Use this fixture only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address or
telephone number listed in the warranty.
• Use only with a 12 VAC or 15 VAC listed low voltage landscape
lighting power supply; maximum secondary output is 300 watts.
• Total combined load of all landscape fixtures must not exceed 72
watts. (Maximum 36-watts per circuit.)
• Do not install within 10 feet (3.05 m) of pools, spas or fountains.
• This low voltage fixture must be installed in accordance with the
National Electrical Code (NEC) and local electrical codes.
• Use only UL / CSA approved low voltage landscape lighting cable,
suitable for direct burial and sunlight resistant.
• National Electrical Code states burial depth of the wiring must
not be more than 6” below grade surface. Check local codes to
ensure compliance with regulations.
• Low voltage cable must be protected by routing in close proximity
to the Haven fixture or next to a building structure such as a house
or deck.
• Fixture connections to the main low voltage cable must be
connected within 6” from the building structure or the Haven
fixture. Coil excess cable length within 6” from the fixture ground
stake.
Safety Warnings