Decorative Fan-Light Ventilateur-lumière décoratif Ventilador-Luz de decorativo Model number: Numéro de modèle : ARN80RB Número de modelo: INSTALLATION AND USE & CARE INSTRUCTIONS INSTRUCTIONS POUR L’INSTALLATION, L’UTILISATION ET LES SOINS INSTRUCCIONES PARA INSTALACIÓN Y USO Y CUIDADO English - See page 2 Français - Voir page 9 Español - Consulte la página 16 © 2016 Broan-NuTone LLC 99045622A
Please visit our websites - www.nutone.com, or www.nutone.ca to register this product and to view installation tips and videos. Installer: Leave this manual with the homeowner. READ AND SAVE THESE INSTRUCTIONS WARNING To reduce the risk of fire, electric shock, or injury to persons, observe the following: • Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.
ALL INSTALLATIONS 1. Remove blower and all packing material from fan housing. Start here. COOKING AREA Do not install above or inside this area. 45o NOT FOR USE IN A COOKING AREA. 45o Cooking Equipment Floor IMPORTANT - The ducting from this fan to the outside of the building has a strong effect on the air flow, noise and energy use of the fan. Use the shortest, straightest duct routing possible for best performance, and avoid installing the fan with smaller ducts than recommended.
6. Connect 4-in. round duct. NEW CONSTRUCTION For Retrofit Installation - Skip to Page 5. 4. Attach damper/duct connector to fan housing. Push connector through opening from inside of housing. Engage tabs and secure with screw from parts bag. 7. Connect wiring. Bend tab to expose desired access hole. Connect power cable to housing with appropriate UL approved connector. Connect black to black, white to white and green to green or bare wire. Re-install wiring panel and secure with screw from parts bag.
8. Install blower. RETROFIT Re-install blower removed in Step 2. Secure blower with 2 screws from parts bag and plug blower into black receptacle. 4. Remove old fan. Enlarge ceiling opening (if necessary) to 9¾” parallel to joist) by 10½” (perpendicular to joist). Leave ductwork and wiring in place. 1 9. Finish ceiling, then install grille. 2 Plug light into receptacle in housing. Attach grille pan to housing with (2) grille mounting screws. Install (2) 60W (Max.) Type A19 bulbs (not included).
. Connect wiring. 7. Mount fan to ceiling structure. Bend tab to expose desired access hole. Connect power cable to housing with appropriate UL approved connector. Connect black to black, white to white and green to green or bare wire. Re-install wiring panel and secure with screw from parts bag. Mount housing to ceiling structure with standard drywall or wood screws in locations shown. *Center hole optional. * 8. Connect 4-in. round duct. Pull existing ducting through housing discharge opening.
MODEL ARN80RB SERVICE PARTS Key No. Part No. 1 Description 1 97019514 Housing 2 97019561 Duct Connector - 4-in. 3 97019516 Wire Panel Assembly 4 97019918 Blower Assembly 5 99528761 Grille Bracket Assembly 6 99528768 Glass Shade 7 99528769 Shade Mounting Hardware 8 Grille Pan Assembly 99528770 (includes Key No. 7) A 99528672 2 3 4 Light Fixture Assembly (includes Key Nos.
Limited Warranty Warranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to the original consumer purchaser of its product (“you”) that the product (the “Product”) will be free from material defects in the Product or its workmanship for a period of three (3) years from the date of original purchase.
