ADA Wiring Instructions

ManualsBrandsNuTone ManualsAppliancesOsmos Deluxe 36 in. Convertible Range Hood in Stainless Steel

ADA LOW VOLTAGE WIRING INSTRUCTIONS FOR SINGLE BLOWER RANGE HOODS (PAGE 1 AND 2)

AND DOUBLE BLOWER RANGE HOODS (PAGE 3 TO 5)

WARNING

For residential (domestic) installation only. Before proceeding, switch power off at service panel and lock service disconnecting

means to prevent power from being switched on accidentally. Installation work and electrical wiring must be done by qualified

person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. Also,

it is recommended to wear safety glasses and gloves.

B Remove filters from the hood and set them aside.

C Remove the wiring cover (shaded part in illustration below) retaining

screw. Slide the wiring cover out of the hood and set it aside with its

screw.

D Unplug the blower connector from the main harness.

NOTE: The illustrations in this procedure are generic; some hood details may slightly differ from the hood you have on hand but the procedure itself applies

to all single blower range hoods listed in this document (see page 2).

Wiring cover

screw

E Using a 11/32'' socket, remove the 6 nuts retaining the blower

chamber to the hood assembly (2 nuts on inner back and 2 other nuts

per sides), then use a Phillips no. 2 screwdriver to remove both front

corner screws. See picture below for nuts and screws locations. Pull

the blower chamber out of the hood assembly and set it aside with its

retaining screws and nuts.

HE0253

HD0672

Nuts

Screw

F Remove and set aside the 4 front screws retaining the control access

panel to the hood.

HD0673

Screw locations

G Fold back the control access panel to access the control panel connections.

HD0674

99045883D

H Measure 4 feet from the connector end of the provided ADA cable

and cut the cable. Set aside the remaining 15-ft. cable section without

connector; it will be used later (refer to step

N). Run the connector of the

ADA cable section through the wiring cable hole on the bent plate.

HE0274

I Connect the ADA cable connector to the 6-pin connector on control

board (circled on picture below).

HE0288

CAUTION

Use exclusively the cable included in this kit.

J Secure the ADA cable section to the main harness using a tie-wrap.

HD0952

Tie-wrap