Installation Guide

INSTALLATION AND USE & CARE INSTRUCTIONS

INSTALLATION

SWITCH BOX

LIGHT

FAN

DUAL CONTROL

(purchase separately)

WHITE

BLACK

RED

GROUND

(bare)

WIRING PLATE

120 VAC LINE IN

RECEPTACLE

(FAN)

RECEPTACLE

(LIGHT)

WIRING DIAGRAM

7. Connect wiring.

Connect power cable to housing with appropriate

UL approved connector (not included). Make wiring

connections as shown in “Wiring Diagram” section.

Re-install wiring panel and secure with screw from parts

bag.

9. Connect 4-in. round duct.

Pull existing ducting through housing discharge

opening.

Attach and tape ducting to duct connector.

Push connector/ducting back through opening.

Engage tabs and secure with screw from parts

bag.

Install blower. Finish ceiling, then

install grille.

See Steps 9 & 10 on Page 5.

8. Mount fan to ceiling structure.

Mount housing to ceiling structure with standard

drywall or wood screws (not included) in locations

shown.

Center hole optional.

TABS