User's Manual

PROGRAMMING
There are 2 different programming methods for the dialer:
1) Programming and testing pendent remotes or sensors.
2) Dial-in Programming (to program emergency phone number)
Depends on what you are programming, you may need to follow different
sequences.
Programming pendent remotes
Allows you to:
1) Add additional remote controls / sensors to the dialer
2) Erase remote controls and sensors
3) Perform range test with remote controls / sensors
To enter programming mode:
Press and hold both green and red buttons for 3 seconds, green LED will flash
one at a time and you will hear 2 beeps, this indicates the dialer is in pendent remote
programming mode.
Note: When pressing both buttons together, press the green button slightly
ahead, otherwise, a panic call may be initiated.
Once you are in programming mode, please refer to the table below for different
programming modes.
Number of Green LED flashes Programming Mode
1 Add pendent remote controls / sensors
2 Erase all pendent remote controls / sensors
3 Remote Operation Range Test
In pendent remote programming, the red Panic button represents “Enter”, so you can
press the red button when you want to select the displayed function.
You can press the green “OK” button as “Skip” , so you can proceed to the next
entry.
Add Pendent Remote Controls / Sensors
Once the dialer is in programming mode, the green LED will flash one at a
time, that means you can now add Pendent remote controls or sensors to the dialer.
1) Press red button when the green LED is flashing one at a time, as Enter to
select this programming mode (Add Remote Controls / Sensors)