User's Manual

INSTALLATION
Emergency Dialer
Locating the Emergency Dialer
Consider the following when locating the dialer in your house. The dialer should
be located:
-near a phone line
-near an AC outlet
-on a desk or countertop where user can reach easily
Note: A conventional telephone can be placed on top of the emergency dialer,
however, the telephone should not cover the microphone or speaker on the
dialer.
Once you have located where the dialer should be installed, you can connect the
dialer to the phone line and AC power.
1. Plug in the phone line – One end of the
telephone cord should be plugged into the
phone outlet on the wall, the other end of
the cord should be connected to the “Line”
socket on the dialer.
2. Plug in the power – Plug the AC adapter
to a nearby AC outlet, the other end should
be connected to the “Power” socket on the
dialer.
3. Connect the rechargeable battery –
Remove the battery cover on the bottom of
the dialer. Insert the rechargeable battery
and plug in the battery connector to the
terminal as shown.
4. Power up the dialer – You may now
power up the dialer by sliding the power
switch to “ON” position. You will hear 3
beeps indicating the dialer is on and all
LED’s will flash once.
5. Standby – The dialer is in standby mode
if the green LED is on. If the green LED is
not on, or if the red LED is flashing and
buzzer beeping, this indicates the dialer is
not connected properly. Please refer to the
“System Failure” section to diagnostic the
problem. 1 2 3