User's Manual

Follow On Choice – Field Number 72
The dialer can be programmed to “Wait command”, “Two-Way Full Duplex
Communication” or listen-in half duplex communication”.
Remote All Device – Field Number 73
The dialer can be programmed to remove ALL previously learnt-in devices.
Panic Call
During emergency, user can press the panic button on the remote control to start
the voice conversation.
1) Press the panic button on the remote control
2) The dialer will start to make the phone call, the red LED will be on and then
flashes to indicate it is calling the pre-programmed emergency phone
number.
3) Once the call is established, both sides can start the conversation. During
the voice conversation, the orange LEDs on the dialer will continue to flash,
to indicate the speakerphone mode is enabled.
4) To terminate the call, the user can simply press the green button on the
dialer, or the recipient can press [9] to terminate the call.
5) Once the call is disconnected, the red LED will be off and the green LED will
be steadily on.
To pick up incoming call.
1. When the phone is ringing, press the Panic button on the remote, it
will pick up the call.
2. To start conversation, speak into the dialer.
3. To hang up after the conversation, press the Panic button again.