User's Manual

• [*] + [2-digit Field Number] + [*]
• Date Content + [#]
6) After enter the [#], you should hear 1 beep as a confirmation of a successive
entry. If you hear 2 beeps, that means what you have entered is incorrect,
you need to try again.
7) To terminate the call, press [0]+[*] on the touch tone phone. Once the phone
line is disconnected, the dialer’s red LED will be off and only the green LED
will be steadily on indicating standby condition.
 Remote Programming Emergency Numbers:
If the system is in Stand By mode with “
Auto Answer
” function enabled, to enter the
Remote Programming mode, follow the steps below.
Step 1.
Dial GM-100 and wait for auto-answering (Default is 20 rings)
Step 2. Enter “123” (the default 4-digit Access Code) followed by “#”, via the phone set.
The GM-100 will respond with two quick beeps to indicate it is ready now for
Remote Programming Commands. The RED LED starts its blinking action to
add visual indication.
Step 3. Proceed to program your system by referring to the Command Table above.
<
<
N
N
O
O
T
T
E
E
>
>
 If the code is not correct, the caller has 15 seconds to enter the correct
Access Code.

If the correct code is not received after 15 seconds, GM-100 will hang
up the line automatically.

If Programming Command is not entered in 2 minutes, the GM-100 will
exit Remote Progrmming Mode and release the line automatically.
 To exit Remote Programming mode, enter “
99
” followed by “
#
”.