User's Manual

Remote Operation Range Test
1) Press green button when the green LED is flashing once, twice and 3 times,
so you are skipping the programming mode until the remote operation range
test. The green LED should now flash 3 times.
2) Press the red button as “Enter” when the green LED flashes 3 times. You
should hear 3 beeps and the red LED will flash 3 times.
3) You are now in the range test mode, activate any pre-programmed remote
control or sensor will activate the siren for 2 seconds and the green LED will
flash once, indicating the dialer can receive the signal successfully. You may
now walk around the premises with the remote control or sensor to check
and make sure the dialer can receive the signal from the remote control and
sensor from different places.
4) After finishing the range test mode, simply press the green or red button once
so the dialer can go back to standby.
PROGRAMING EMERGENCY PHONE NUMBERS
The number of information can be programmed by local programming is limited.
To program all required information, “Call-in” programming should be used.
First, the dialer must be connected to a phone line and function properly, i.e. with
the green LED steadily on without any red LED flashing.
1) With a touch tone phone, call the phone number that the dialer is connected
to.
2) When you hear the ringer on your touch tone phone, press the green button
on the dialer. The dialer will beep once and you will see the red LED steadily
on, indicating it has picked up the phone line.
3) Enter a programming code, which is “123” on your touch tone phone. You
will hear 4 beeps. If you enter the wrong code, you will hear only 2 beeps.
You must enter the correct programming code “123” in order to begin
programming the emergency phone number.
4) After hearing the 4 beeps, enter the following to program the required
field(s).
5) Enter: