User's Manual

2) You will now see both red and green flash one at a time. The red LED now
represents you have entered the “Add Remote Controls / Sensors”
programming mode. The green LED represents the location you want to
add the new remote controls or sensors. There are 4 different locations, 1,
2, 3, or 4.
3) To select location 1, press red button as “Enter” when the green LED is
flashing once.
4) To select location 2, press green button as “Skip” when the green LED is
flashing once, so the green button will now flash twice. Press red button
as “Enter” to select location 2.
5) To select location 3, press green button as “Skip” when the green LED is
flashing twice, so the green button will now flash 3 times. Press red button
as “Enter” to select location 3.
6) To select location 4, press green button as “Skip” when the green LED is
flashing 3 times, so the green button will now flash 4 times. Press red
button as “Enter” to select location 4. Note: If you press green button again
to skip, you will quit from programming.
7) Once the location is selected, the dialer will emit 3 beeps indicating you
can now activate the remote control or sensor you would like to add to the
dialer.
8) Once the signal is received and programmed to the dialer, the dialer will go
back to step 2, where you can add more remote controls / sensors.
9) To quit, just press the green button until you hear a long beep and green
LED steadily on, that indicates the dialer is back to standby mode.
Erase All Remote Controls / Sensors
Follow the sequence below to erase all the programmed remote controls and
sensors. You cannot erase just one remote control or sensor. You must first
erase all and then program the ones you would like to keep.
1) Press green button when the green LED is flashing one at a time, so you
are skipping the add remote control programming mode. The green LED
should now flash twice.
2) Press the red button when the green LED flashes twice. Once the red button
is pressed, you will hear 3 beeps and the green LED will be on steadily, this
indicates you have now erased all the programmed remote controls and
sensors.