User's Manual

Controller & Transmitter Functions (cont’d)

TRUNK RELEASE / CHANNEL 2: Press the TRUNK button for 3

seconds�

• THE SYSTEM WILL DISARM AND THE TRUNK WILL

OPEN (IF EQUIPPED)�

• UPON RECEIVING CONFIRMATION FROM YOUR

SYSTEM, THE CONTROLLER WILL PLAY THE TRUNK

RELEASE ANIMATION AND BEEP TWICE

(1-WAY TRANSMITTER: PRESS AND HOLD THE TRUNK

BUTTON FOR 3 SECONDS)

REMOTE START: Press and release the START button twice within

5 seconds� (see user feature #8 for additional options)

• THE PARKING LIGHTS WILL FLASH ONCE AND THE

STATUS LIGHT WILL FLASH RAPIDLY�

• THE SYSTEM WILL TURN ON THE IGNITIONS AND

PROCEED TO START THE ENGINE�

• ONCE THE ENGINE IS RUNNING, THE PARKING

LIGHTS WILL FLASH AND THE STATUS LIGHTS WILL

FLASH SLOWLY�

• UPON RECEIVING CONFIRMATION FROM YOUR

SYSTEM, THE CONTROLLER WILL PLAY THE REMOTE

START ANIMATION AND PLAY A MELODY�

• THE CLOCK WILL CHANGE TO 0:00 TO START THE

REMOTE START TIMER� IT WILL TIME HOW LONG THE

ENGINE RUNS IN MINUTES & HOURS�

(1-WAY TRANSMITTER: PRESS THE START BUTTON

TWICE IN 5 SECONDS)

• If the engine stalls, the system will make up to 3 more attempts�

• Each time you park your vehicle, set the climate controls to give you the de-

sired interior temperature when you use the remote start�

The engine will run for the preset run time (see user feature #1)�

• Run Time Extender: Press the START button one time while in remote start

mode to restart the engine run timer� The timer on the controller will restart at

“0:00”�

NOTE: This can only be used once per remote start cycle. The controller will also give you

“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.

• If you decide not to drive your vehicle, you can turn off the remote start using

the same method to turn it on (Default = press START twice in 5 seconds)

NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so

an additional press is required.

• Upon entering the vehicle during remote start mode, turn the ignition key to

the “ON/RUN” position (NOT START!!)� When you press the brake pedal, the

remote start will turn off allowing the ignition key to take over�