User's Manual

17
DEMO MODE
Demo mode will show you a demonstration movie of all the controller’s conrma-
tion animations and alerts� To view demo mode, use the following steps�
1) Press the “P” button for 3 seconds to access options�
2) Scroll down until “DEMO” is highlighted
3) Press the 4 button to select�
Programming Controller Options (cont’d)
PARKING TIMER: Press LOCK twice within 5 secondsto start the timer�
REMOTE START TIMER: This turns on every time you remote start�
Note: Pressing the “P” during either timer mode will switch between the
timer and clock.
PARKING TIMER & REMOTE START TIMER
SELECTING BUTTON BEEP
With this option turned ON, the controller will beep to con-
rm each button press. The default setting is OFF. To turn
ON/OFF, use the following procedure:
1) Press the “P” button for 3 seconds to access options�
2) Scroll down until “Button Beep” is highlighted
3) Press the 4 button to select�
4) Scroll up or down to highlight the desired setting�
5) Press the 4 button to select�
SELECTING MELODY & VIBRATE MODES
The controller can give you 2-way alerts with a melody, vibration, or both� By
default, the controller is set for melody only� Press the “P” and trunk buttons
simultaneously for 2 seconds to change the setting. The sequence is VIBRATE
only, MELODY + VIBRATE, MELODY only� The melody and vibrate icons at the top of
the status screen will change to indicate your selection�
This option allows you to select from 5 different melodies to
indicate when remote start is turned on and off� To change
the setting, use the following procedure:
1) Press the “P” button for 3 seconds to access options�
2) Scroll down until “Melodies” is highlighted
3) Press the 4 button to select�
4) Scroll up or down to highlight the desired setting�
5) Press the 4 button to select�
This option allows you to select Farhenheit or Celsius for the temperature display:
1) Press the “P” button for 3 seconds to access options�
2) Scroll down until “Temp Display” is highlighted
3) Press the 4 button to select�
4) Scroll up or down to highlight the desired setting�
5) Press the 4 button to select�
SELECTING REMOTE START MELODIES
SELECTING TEMPERATURE DISPLAY UNIT