User's Manual

4 PIN DOOR LOCK PORT
Lock (-) Out - GREEN
Constant 12v (+) Out - PIN
Unlock #1 (-) Out - BLUE
Unlock #2 (-) Out - PINK
3 PIN SAT. RELAY PORT (RED)
Start (-) Out - GREEN
Constant 12v (+) Out - RED
Ignition (-) Out - BLUE
4
BLADE HARNESS PORT
BLACK BLADE PROGRAMMING /
INTERFACE MODULE DATA PORT
GREEN INTERFACE
MODULE DATA PORT
BACKUP
BATTERY
PORT
WINDOW-MOUNT ANTENNA MODULE
Status Light
Valet / Programming
Button
4 PIN AUX HARNESS
OEM Disarm (-) Out - LT. GREEN/BLACK
3
OEM Arm (-) Out - LT. GREEN/RED
3
RS Activation (-) In - WHITE/BLUE
3rd Channel (-) Out - PINK
3 PIN SAT. RELAY PORT (BLUE)
Accessory (-) Out - GREEN
5
Constant 12v (+) Out - RED
Status (-) Out - BLUE
3
VEHICLE LEARN PROCEDURE
1. Connect any interface module(s) to the
data port(s) and set for data mode.
2. Turn the ignition key ON (do not start)
3. Activate remote start
System will chirp/ash lights to indicate engine
type (Default: 1x = Gasoline)
4. Press valet to change engine type:
1 chirp=Gasoline, 2 chirps =Diesel 15,
3 chirps=Diesel 20, 4 chirps=Diesel 30
5. Start the engine with the ignition key
6. Turn the ignition key OFF
System will chirp/ash lights equaling the # of
IGN/ACC/START circuits detected (Max: 4x)
7. Within 20 seconds of Step 6, Activate
remote start. Wait until engine is running
and LED is ashing slow.
8. OPTIONAL: To enable Manual
Transmission Reservation mode, release
and set parking brake again.
System should chirp/ash lights 1x.
9. TO SAVE SETTINGS: Shut down RS by
pressing the BRAKE pedal.
TO CANCEL/START OVER: Shut down
RS by remote or input wire.
~ See Page 12 For Full Details ~
Wiring Overview Diagram
Receiver part number: REC-1N4
Transceiver (2-way) part number: REC-2N4-3D, REC-2N9-3D