User's Manual

4 Pin Secondary Wire Harness

PINK WIRE - 3RD CHANNEL (-) OUTPUT

This output provides a 250mA negative output when the CH3 function is activated by the

controller. The output will remain as long as the controller button is held.

CONNECTION: Connect this wire to any desired add-on accessory that can utilize a negative

activation input.

WHITE/BLUE WIRE - REMOTE START ACTIVATION (-) INPUT

This input will activate the system’s remote start function when it receives 3 negative pulses.

Repeating this during remote start will turn off the remote start. You can change this to 1, 2, or 4

pulse activation with installer feature #1.

CONNECTION: Connect to any device you desire to activate remote start. It can be connected

directly to doorlock motor wires for activation from OEM keyless entry if the wire rests at ground &

pulses positive. The return to ground is counted as 1 pulse. NO RELAY IS NEEDED.

LT. GREEN/RED WIRE - OEM ALARM ARM / CH4 (-) OUTPUT

This output provides a 250mA negative pulse before remote start & when the system’s alarm is

disarmed. It can be programmed for 5th channel output with installer feature #18.

CONNECTION: Connect this wire to the vehicle’s OEM alarm disarm circuit. Typically, it will show

ground when the door cylinder key is turned to the unlock position.

LT. GREEN/BLACK WIRE - OEM ALARM DISARM / CH5 (-) OUTPUT

This output provides a 250mA negative pulse when remote start is turned off & when the

system’s alarm is armed. It can be programmed for 4th channel output with installer feature #18

CONNECTION: Connect this wire to the vehicle’s OEM alarm arm circuit. Typically, it will show

ground when the door cylinder key is turned to the lock position.

3 Pin Satellite Relay Port (RED)

GREEN WIRE - START (-) OUTPUT

This output provides a 250mA negative pulse when the large VIOLET start wire is active.

CONNECTION: If a negative starter circuit is needed, connect this directly to the vehicle’s

negative starter circuit. Otherwise, use a relay (AU-7) to convert this to a high current circuit.

BLUE WIRE - IGNITION/ACC/START (-) OUTPUT

This provides a 250mA negative output when the large PINK ignition wire is active.

CONNECTION: If a negative circuit is needed, connect this directly to the vehicle’s negative

starter circuit. Otherwise, use a relay (AU-7) to convert this to a high current circuit.

RED WIRE - CONSTANT (+) OUTPUT

This output provides a 500mA positive output to drive the positive pin of added relay coils.