User's Manual

18 Pin Secondary Wire Harness (cont’d)
RED/WHITE WIRE - TRUNK RELEASE / 2ND CHANNEL (-) OUTPUT
This output provides a 250mA negative output when the trunk release/CH2 function is activated
by the controller. The output will remain as long as the controller button(s) is held.
CONNECTION: Connect this wire to the vehicle’s existing trunk release switch if it is a low current
negative circuit. If the circuit is a high current ground or a positive circuit, the use of a relay is
required. NOTE: The built-in horn relay circuit can be programmed for trunk release if not
being used otherwise.
BLACK/RED WIRE - LIGHT RELAY PIN 87 (+/-) INPUT
This circuit provides the constant feed input for the built-in 10 amp light relay. This relay can be
programmed via installer feature #5 for other functions.
CONNECTION: Connect this wire to constant power or chassis ground as needed.
GREEN/VIOLET WIRE - LIGHT RELAY PIN 30 OUTPUT
This circuit provides the output for the built-in 10 amp light relay. This relay can be programmed
via installer feature #5 for other functions.
CONNECTION: Connect this wire to the vehicle circuit chosen to be driven. By default, connect to
the vehicle’s parking light circuit.
WHITE/RED WIRE - LIGHT RELAY PIN 87A (+/-) INPUT
This circuit provides the input for the built-in 10 amp light relay. This input is typically only
used for polarity reversing circuits or circuits that must be broken to operate. This relay can be
programmed via installer feature #5 for other functions.
CONNECTION: Connect this wire to constant power or chassis ground as needed.
VIOLET/BLACK WIRE - HORN RELAY PIN 87 (+/-) INPUT
This circuit provides the constant feed input for the built-in 20 amp horn relay. This relay can be
programmed via installer feature #19 for other functions.
CONNECTION: Connect this wire to constant power or chassis ground as needed.
BLUE/BLACK WIRE - HORN RELAY PIN 30 OUTPUT
This circuit provides the output for the built-in 20 amp horn relay. This relay can be
programmed via installer feature #19 for other functions.
CONNECTION: Connect this wire to the vehicle circuit chosen to be driven. By default, connect to
the vehicle’s horn circuit.
BROWN/BLACK WIRE - HORN RELAY PIN 87A (+/-) INPUT
This circuit provides the input for the built-in 20 amp horn relay. This input is typically only
used for polarity reversing circuits or circuits that must be broken to operate. This relay can be
programmed via installer feature #19 for other functions.
CONNECTION: Connect this wire to constant power or chassis ground as needed.
6