User's Manual

Green Data Port

This port provides a direct digital interface for any interface module, or other accessories,

using either the DBI protocol or iDatalink protocol. It eliminates the need for several wire-to-wire

connections. Refer to the wire diagram overview on page 8 to see which circuits are supported

by this port & compare them to the data functions available from the interface module. This port is

capable of using the D2D/DBI (Trilogix/Directed) protocol & iDataLink protocol. THIS PORT WILL

AUTO SELECT THE PROTOCOL DURING VEHICLE LEARN. MAKE SURE ANY CONNECTED

DEVICE IS PROPERLY CONNECTED & PROGRAMMED BEFORE HAND. The protocol is

manually selectable with installer feature #12. This port operates independently from the black

data port described below. BOTH THE GREEN & BLACK PORT CAN BE USED SIMULTANE-

OUSLY FOR PLUG-IN ACCESSORIES.

Black Data/Programming Port

This port operates exactly like the Green port & adds programming capability. THIS PORT

WILL AUTO SELECT THE PROTOCOL DURING VEHICLE LEARN. MAKE SURE ANY CON-

NECTED DEVICE IS PROPERLY CONNECTED & PROGRAMMED BEFORE HAND.

BLADE OPERATIONS: This port is also used to update the rmware for any BLADE cartridge

used instead of a standard interface module. When connected to the OmegaLink OL-LOADER,

this port can also be used to congure all programmable features as well as update the entire

system’s rmware. NOTE: Installing a BLADE forces this port to iDatalink protocol.

When utilizing an OmegaLink BLADE module, this 20 pin connector is used for the harness

that is included with the BLADE module. This allows you to connect directly to the vehicle’s data

bus & other required circuits for the interface.

BLADE Cartridge Port

On the top of the main module, there is a slide door. This door is removed & replaced with any

OmegaLink BLADE cartridge being used. The port is keyed so the cartridge will only insert one

way. Do not use excessive force to install the BLADE, it should snap in with light to moderate

pressure. Also, refer to the install guide for the BLADE rmware being used, for further informa-

tion & details. When this system detects a BLADE module, the data port protocol will automatic

switch to the iDatalink protocol. For more info on BLADE modules, visit www.omegaweblink.com.

There are notches in the corners of the port to safely eject the cartridge when needed.

Dual Zone Sensor Ports (WHITE)

This system is equipped with 2 white dual zone sensor ports. Any Omega single or dual zone

sensor will plug directly into these ports. A dual zone shock sensor is included with this system. If

more than 2 sensors are desired, you must diode isolate & splice into the GREEN & BLUE wires.

FOR “RS” MODELS: By default alarm functions are off w/ sensor detect enabled. If a pre-warn

trigger or full trigger is detected, it will automatically enable security functions.

BLADE CARTRIDGE PORT

BLADE HARNESS PORT