User's Manual

Installer Programmable Features (cont’d)
This device complies with FCC Rules part 15� Operation is subject to the following two
conditions, (1) This device may not cause harmful interference and, (2) This device
must accept any interference that may be received, including interference that may
cause undesired operation�
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modications to this equipment. Such modications could void the user’s
authority to operate the equipment�
Feature #17 Low Temp Crank Extender
0ms (press LOCK to program)
200ms (press UNLOCK to program)
300ms (press TRUNK to program)
400ms (press START to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra crank
time to the base timing (see installer feature #7)� It applies to tachless modes only
(installer feature #3)�
Feature #20 Low Current / Motorcycle Mode
On (press LOCK to program)
Off (press UNLOCK to program)
This feature, when on, reduces the system’s current draw by as much as 40% to maxi-
mize the vehicle’s battery life while the alarm is armed� It causes the starter interrupt
output to only operate when the ignition is turned on and reduces the frequency of the
“armed” ashing status light signicantly. This is ideal when the system is to be used on
vehicles that have limited battery capacity and/or may sit for extended periods without
charging the battery�
Feature #18 - Arm, Disarm or Additional Channels
Arm / Disarm (press LOCK to program)
Arm / Channel 5 (press UNLOCK to program)
Channel 4 / Disarm (press TRUNK to program)
Channel 4 / Channel 5 (press START to program)
The system has outputs designed for arming and/or disarming a factory-equipped security
system� These wires may be used instead to provide further system outputs, which are
remotely operated by the controller or transmitter� These outputs are in addition to the
2nd channel and 3rd channel outputs� As shown in the programming assignment, the
arm, disarm, channel 4 and channel 5 are programmable as various combinations� For
example, if the disarm output is needed, but not the arm output, then channel 4 may be
made available for use�
Feature #19 - Horn Relay Function (3DB) / Brown Wire Function (non-3DB)
Horn Output (press LOCK to program)
Ignition (press UNLOCK to program)
Trunk Release (press TRUNK to program)
Pulse After Start (press START to program)
The primary function of this output, is to operate the vehicle’s existing horn� Optionally, if
desired or needed, this output can be programmed for the other functions listed above�
3DB models utalize a built in relay� Non-3DB models use a 1 amp negative output on the
Brown wire�
22