User's Manual

Other Remote Start Features (cont’d)
MANUAL TRANSMISSION STARTING
Remote starting with a manual transmission requires that you ensure the gear selector
is in NEUTRAL� There are 2 available methods�
METHOD #1 - 3D MOTION SENSOR:
Some models are equipped with a 3D motion sensor built into the antenna (optional
sensors are available as an upgrade)� Whenever remote start is activated, this sensor is
monitored for vehicle movement� If the vehicle moves just a few inches when the engine is
cranking, it will instantly turn the engine off� This safety feature allows you to enjoy remote
start without performing reservation mode as described below
METHOD #2 - RESERVATION MODE:
For extra safety, installer feature #11 can be turned on which requires you to perform a
setup procedure that ensures the transmission was left in neutral when you park your
vehicle� This must be performed each time you leave your vehicle to use remote start
later� To do so, follow these steps:
1) With the engine running via the ignition switch, hold the brake pedal, apply the parking
brake, then release the brake pedal�
2) Use the transmitter as if you were activating remote start (default: press START twice)�
The status light will start to ash slow.
3) Turn off the ignition key and exit the vehicle�
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is on)
and the status light will ash every 2 seconds (ready to be remote started).
NOTE: Manual transmission starting is canceled if you enter the vehicle after
performing the setup procedure.
Security System Features
LAST DOOR ARMING
This system can be congured to arm automatically when all the vehicle’s doors
are closed (see user feature #9)� When this feature is utilized, the siren/horn will chirp
once when all of the doors are closed� At that point, it will start a 30 second countdown
(indicated by a fast ashing status light). After 30 seconds, the system will arm (and lock
the doors if congured to do so). During the 30 second arming delay, if a point of entry is
opened, the countdown will pause until all entry points are closed again� Turning ON the
ignition key will cancel the last door arming sequence until the key is turned off and the
doors are all closed once again�
AUTOMATIC REARMING
This automatically rearms the alarm if the system is disarmed from the remote
(see user feature #10)� When disarmed by remote, the system will start a 90 second
countdown (fast ashing status light) to arm the system. This is useful if the controller
accidentally disarms the system when it’s kept in a purse or pocket where other items
could potentially press the buttons� ENHANCED AUTO REARM allows you to cancel
the countdown by pressing UNLOCK a second time within 5 seconds of the rst press to
disarm the alarm�
PRE-WARN DETECTION
This system’s impact sensor is designed, in addition to detecting a full impact, will warn
away potential violators when it detects a light impact to the vehicle� The
system will respond by chirping the siren/horn 3 times and locking the doors�
9