User's Manual

The controller can operate up to 2 different systems. When controlling 2 systems, it will
receive all status updates on the currently selected vehicle prole and will receive only
trigger alerts for the 2nd vehicle. You can switch from one car to the other at anytime. Use
the following steps to change vehicles.
SELECTING CAR #1 OR CAR #2
Vehicle #1: Press the “P” and LOCK buttons for 1 second to select Car #1. The controller
will beep once and ash the LOCK LED once.
Vehicle #2: Press the “P” and UNLOCK buttons for 1 second to select Car #2. The con-
troller will beep twice and ash the UNLOCK LED twice.
Multi-Car Operation
Controller Options
SELECTING MELODY, SOFT MELODY, & MUTE MODES
Whenever 2-way alerts are received from the system, the controller can alert you with a
melody, soft melody, or visual only. By default, the controller is set for melody only.
Hold the “P” then TRUNK buttons simultaneously for 1/2 second to change.
You can lock the buttons on the controller to prevent accidental button presses. To lock
the buttons, hold “P” then START simultaneously for 1 second. Repeat this to unlock the
buttons. While the buttons are locked, all 4 LEDs will ash when you press any button.
BUTTON LOCK
All primary commands sent to the system have a conrmation response that is sent
to the controller to indicate that the command was successful. If no response is received
within a few seconds, all 4 LEDs will ash once indicating that you may be out of range of
your system.
IN-RANGE INDICATOR
12